You will need:
20 – 30 1″ metal washers (I used 24. Use more or less to make it the length you want.)
5/8″ wide grosgrain ribbon, about 1 yard (or more, depending on your desired length of your necklace)
Step 1:
String your ribbon up through washer, leaving enough lace on the end to tie the jewelry when its done.
Step 2:
String your ribbon down through the top of the washer.
Step 3:
Now thread the ribbon back down through washer.
Step 4:
Pull the ribbon tightly, it should be lying on the top of washer.
Step 5:
Thread the ribbon back up through washer
Step 6:
Repeat steps 2 through 5 for each additional washer. Once you’ve threaded all your washers onto the ribbon, tie the two ends of the ribbon together and trim off the excess. Finished! Easy, right?
***DIY source: www.nestledblog.blogspot.com
Leave a Reply