DIY Home Improvement Tips: HOW TO MAKE ARM CHAIR SLIPCOVERS FOR LESS THAN $30

This easy and budget-friendly upholstery project uses canvas drop cloths to give an old set of chairs a new cottage-chic look.

CI-Susan-Teare_Recovered-Chairs-2_s4x3_lg

Tools and Materials

– pinking scissors
– strong large needle
– hammer
– 2 to 3 canvas drop cloths (8-or 10-ounce tight-weave unbleached cotton) 6′ x 9′ or larger — depending on the size of the chair.
– button thread in the same color of canvas cloth
– 2 cans adhesive spray (we used Elmer’s multi-purpose)
– upholstery nail heads (found at hardware store)

This is what they looked like before:

Original_Upholstry-project-before_s4x3_lead

 

Cut and Lay Out Each Section

Cut the drop cloth into big pieces to cover each large section of the chair. We tucked and folded at the seams to get a finished look. In some areas we just glued down the fabric to the chair, but in other spots we had to hand stitch some of the pieces together.

Original_Upholstry-project-skirt3_s4x3_lg

 

Cover the Arms

We used the finished edges of the canvas in the most visible spots — along the arms and back. The arms are two seperate pieces — the inner piece folds over the outer piece.

Original_Upholstry-project-Covering-arms_s3x4_lg

 

If necessary, cut each piece down further to the approximate size — make sure you cut extra to allow for curves and padding. Slowly place each piece down with the adhesive spray, pressing along the way to take out folds or wrinkles. The spray is forgiving, so if you need to pull it back up you can, and then place it back down.

Original_Upholstry-project-second-arm_s4x3_lg

 

Cut one piece at a time and make sure the edges are finished edges. Tuck in or folded over to give each seam a finished edge.

Original_Upholstry-project-base-covered_s4x3_lg

Wrap the Skirt

We did the chair’s skirt last to cover the bottom edges of all the other pieces. You can do the skirt as one long piece wrapped all the way around or do separate pieces on each side of the chair.

Original_Upholstry-project-putting-on-skirt_s4x3_lg

 

Cover Cushions and Add Nail Trim

When all the pieces are in place and are glued down, use the hammer to insert the upholstery nail heads through the fabric and into the chair’s framing. All chairs vary, on some you can feel the framing in the arms, others the on the back and some around the edges.

Original_Upholstry-project-nail-head-on-back_s4x3_lg

 

Final Stitching

The chair will need to be stitched together at the many of the seams to hold fabric in place. The adhesive is more of a temporary solution to get the pieces in their exact spots. The stitching will give it a rustic chic look.

Original_Upholstry-project-close-up-cushion_s4x3_lg

Original_Upholstry-project-stitching-front_s3x4_lg

Leave a Reply

Your email address will not be published. Required fields are marked *

Top