Connecting Faucets with Supply Tubes

bath-faucet-4

Connecting your faucet to hot and cold water supply tubes is an easy project.  Start by measuring the distance between your faucet and the shut-off valves.  Add 4” to allow for any twists and turns then purchase the correct length of braided steel or vinyl mesh faucet supply tubing to connect your faucet to the hot and cold shut-off valves. Be sure the supply lines you purchase have the right connection types for your shut-off valves. Read the Labeling section of our Flexible Supply Lines buying guide and watch our Plumbing Compression Fittings video to learn more about these connections. As you refer to the steps in this guide, be sure to follow any specific instructions that come with your faucet or supply connectors.

dpb104_1fl_lg

WHAT YOU NEED FOR THIS JOB:

TOOLS:

MATERIALS:

FH02DJA_KITFAU_11

Step 1: Turn Off Water

Step 1: Turn Off WaterTurn off the water at the shut off valves under the sink or at the main water supply.

Step 2: Attach Supply Connectors to Faucet

 Step 2: Attach Supply Connectors to FaucetIf your faucet comes with supply connectors already attached to the faucet, skip this step and proceed to step three.1. Wrap Teflon tape or thread sealant around the threads on the faucet’s male hot
and cold fittings.2. Attach the supply connectors to the faucet body.3. Label the hot and cold supply connectors so you can attach them to the
appropriate tubes when you’re under the sink.

Step 3: Attach the Faucet

Step 3: Attach the Faucet1. Insert the threaded tailpiece(s) and supply connectors into the pre-drilled holes
in the sink or countertop.2. Secure the faucet to the sink by placing a rubber gasket, retainer ring and nut
onto the threaded tailpiece.3. Tighten the nut with your fingers then give it a quarter-turn with a basin wrench or
a pair of water-pump pliers. Be careful not to crack the countertop by over
tightening the nut.

Step 4: Connect the Supply Lines

Step 4: Connect the Supply Lines1. Wrap all male threads with Teflon tape or apply some form of thread sealant.2. Use two adjustable wrenches to connect the hot (red- coded) and cold
(blue-coded) supply lines to the shutoff valves.

Step 5: Test for Leaks

Step 5: Test for Leaks1. Turn on the water.2. Check for any leaks around all new connections.3. Check and tighten connections where any leaks occur.

FH08MAR_LAUSIN_05

One thought on “Connecting Faucets with Supply Tubes

  1. westmountwaterworks

    Thanks for sharing such a very useful post Its good to be here, very nice post, the content is amazing, keep posting friend it will be very helpful for everyone, Thanks for sharing. I really liked it.

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *